ORACLE Lighting Jeep Wrangler JL & Gladiator JT SPORT High Performance 20W LED Fog Lights

A complete high-powered LED fog light replacement engineered specifically for the Sport and Sport S trim of the Jeep Wrangler JL and Gladiator JT. These direct-fit units push approximately 3,000 raw lumens using Philips ZES 5W LEDs with advanced optics for optimal visibility and a precision no-glare beam pattern. The rugged polycarbonate housing withstands impact, the solid-state luminaire design resists vibration, and epoxy-sealed electronics prevent moisture and corrosion - built for on-road and off-road use.

Available with an optional ORACLE SMD halo pre-installed in your choice of solid color or ColorSHIFT®.

• ~3,000 Raw Lumens: High-powered output guaranteed to light up on-road and off-road terrain
• Philips ZES 5W LEDs: High-performance LED chips for superior output and longevity
• Advanced Optics: Precision no-glare beam pattern for optimal visibility without blinding oncoming traffic
• Vertical Beam Adjustability: Dial in your beam angle for the perfect aim
• Polycarbonate Housing: Impact-resistant construction for rugged use
• Solid-State Luminaire Design: Vibration-resistant - built for off-road conditions
• Epoxy-Sealed Electronics: Moisture and corrosion protection
• Direct Plug & Play: Fits directly into the factory fog light location - no modification required
• Optional ORACLE SMD Halo: Pre-installed halo available in White, Blue, Red, Green, Amber, or ColorSHIFT®
• Black Bezel: Aggressive OEM+ styling

• (2) ORACLE 20W LED Fog Lights - Jeep Wrangler JL & Gladiator JT Sport
• Pre-installed SMD Halo (if applicable variant selected)
• 2-Year Warranty

White or Amber Halo - Additional wire may be needed.

• DRL wire cannot be used as a power source.
• Tapping into Park Lights gives manual control over the LED accessory during daytime driving.
• LED accessory turns on automatically in night mode when the switch is set to AUTO.
• For full automatic control, use fuse F52 in the engine compartment fuse panel.

Red, Blue, or Green Halo

• Extend Red (+) wire to controller, toggle switch, or existing headlight halo.
• Extend Black (−) wire to common ground.

Direct plug-and-play installation into the factory fog light location. Refer to the halo wiring guide above if your variant includes a halo. Vertical beam adjustability allows fine-tuning after installation.